So i was an idiot and didn't label the wires when I removed them from my old Coleman Mach analog 6 wire thermostat... /sigh
Anyways, I picked up a Honeywell thermostat, and installed it in the spring... I was able to get the furnace hooked up, but not the A/C. Didn't worry about it at the time... Then i needed the A/C and got that working but not the heat. didn't take any pictures of the heat configuration that worked...
Long story short, I need heat now, and I can't figure out the proper config to get the furnace working again...
Imgur Album of relevant photos
So the main issue I'm having is that from the wall, there are two yellow wires and two white wires... There are also two red wires, but one in the wall wasn't hooked up to anything (?). According to the Coleman Mach wiring schematic, the blue wire is the -12v.. And in the original pic I had a white and a yellow connected to it.... One for AC, one for Furnace? As I've mentioned, I have TWO yellow and TWO whites... how do I figure out which is which?
My trailer is an Innsbrook Supreme 2001 with the roof top AC and the Suburban furnace...
My trailer is about 3 hrs from a cell connection, so I can't run outside, try something and come back in. As I'm heading out there tomorrow for a couple of days, I'll be taking any suggestions with me, digitally to see if I can get the beast up and running again :D
Thanks for your time!
[link] [comments]
No comments:
Post a Comment